AnalogBlox input and output modules typically connect to carriers through 34 pin ribbon cable. Clockworks offers two standard lengths, 6″ (152mm) and 18″ (457mm). The long cable is typically used on output connections where the output connector module is mounted on the same panel as the input connector module and must therefor wrap under (or […]
The MTA-100 connectors provide a simple way to create custom interconnect cables without need for expensive tooling. All Clockworks products use a standard connector arrangement to carry power, control, and status. Details of the pinout can be found in the SignalBlox System Configuration guide. The 8 pin connector carries the analog +/-15V and +/-5V supplies, […]
To aid A2B developers Clockworks offers A2B cables that conform to the cable requirements specified by Analog Devices. These cables use the mating connectors for the (Molex) DuraClik connector used on Clockworks’ and Analog Devices’ development boards. Quality Belden two conductor 100 ohm impedance cable is used, and the ends are finished with a small […]